Carbon fiber reinforcement

Home»Carbon fiber reinforcement

Carbon fiber reinforcement

This is "composite structure construction method" which uses fiber instead of steel sheet that has been uesd mainly as a reindorcement material so far.

img2_1
img2_2

Use

It is highly innovative repair and reinforcement method to improve the structural function such as strength, durability and earthquake resistance that using epoxy resin to bond the unidirectional carbon sheet with concrete which lacks of capacity.

 

Feature

High strength and elasticity
Carbon fiber sheet is unidirectional so to have high strength and elasticity.
Light weight
fibers are four times lighter than steel so there's little affect to the structure's weight.
Excellent durability, corrosion resistant and waterproofing
As it is a composite material reinforcement using carbon fiber and epoxy resin, It's non-corrosive to outside air such as water, alkali, acid and ultraviolet, never degraded and has waterproof effect due to resin.

Effect

Improvement of bending capacity
Reinforcement with carbon fiber is effective to improve the bending capacity of structure, and if you bond the carbon fiber sheet to the tensile side of concrete structure whose capacity will be greatly increased.
Improvement of Abrasion resistance
Carbon fiber reinforced surface has more great abrasion resistance than original concrete surface.
Reinforcement of crac
Cracks caused by fatigue, impact and excessive load is reinforced by carbon fiber, so the capacity of structure can be recovered, the reinforcement restrains cracks from activating.
in_1
1. Crack repair
Repair of Cracks within targeted structure is ahead of carbon fiber reinforcement process.
in_2
2. Surface Preparation
Prepare the surface using disk grinder.
in_3
3. Primer spray
* Standard spray quantity
- Solvent type: 0.40㎏/㎡ Solvent
- less type: 0.25㎏/㎡ Epoxy
- primer → Mixing ratio (Resin 2: Hardener 1)
in_6
4. Apply epoxy putty
Use metal spatula or scoop to adjust the surface of epoxy putty. Epoxy putty →mixing ratio (Resin 1: hardener 1)ner 1)
in_5
5. Epoxy spray to surface
Standard spray
Amount : 0.3㎏/㎡
Mix ratio (Resin 2: Hardener 1)
in_4
6. CF Sheet adhesion
After removing protective sheet, adhesive the CF on to the structure to be reinforced
in_7
7. Remove air in the sheet
Using roller removes air in the fiber sheet according to its weave.
in_8
8. Spray epoxy resin(finish)
*Standard spray
quantity:0.2㎏/㎡ → mixing ratio (resin 2: hardener 1)
in_9
9. Finish
Remove excessive resin with rubber scoop and finish the surface.